Posted by JamesF on April 07, 2015 at 11:39:03 from (68.217.197.234):
My 1943 Farmall H tractor lift-all system has 850 psi of pressure. When I pull the lift-all lever out the hydraulic cylinder attached to the system extends, when the lever is pushed back in it will not come back down even with a heavy weight on the unit. The only way I can get the cylinder to come down is disconnect the hydraulic line, releasing oil and pressure. I am guess the problem is a stuck relief valve in the internal lift-all system. I have tried connecting the hydraulic hose to other ports on the system, but the same results. I have tried pulling the lever constantly, the pressure goes up to 850 psi and when I push the lever in the psi drop to 600 and then later 400 and eventually to 200. Is there a way of releasing a stuck valve in the lift-all system without dropping and opening up the lift-all system? Help.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.