Posted by Paul Shuler on April 06, 2015 at 06:15:47 from (170.29.1.10):
This is an update to a post I had on Friday. After trying everything suggested I ended up having to drill all but one of those screws out of the brake drums. When I got the drums off I found out what a mess I had. The wheel cylinders where falling apart. The drums where egg shaped. And like someone said Friday I found that one of the axle seals had been leaking a lot. I have never pulled an axle out before so that was a real treat. Took me about two hours to figure with all the dirt and rust that there where little cone shaped doo dads around the bolts holding the axel in. Forgot to mention the steal brake lines came apart in my hands. If all of my parts come in today I should be putting things back together tonight. One question I have is this. There is two large 2 3/8 nuts with a locking washer between them. Took all I had to get that outer on off. What is the correct thing to do as far as adjusting how tight that inner nut should be against the bearing. Sorry if this is a dumb question. I have done lots of front wheel bearings but this is quite a bit a different critter. Thank you all so much for all the help on Friday. I tagged on some pics if they work to show the progress and the mess I have been in.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.