Answer is basically yes. I believe the lower housings and the main core components of lower housings of the governors to be identical based on posting from this sites archives.
That said, I believe you will have to swap the drive gears as they are diffent size between an h and m The shaft that the gear mounts to is same size so they will swap.
Not sure if the governor spring is same or not but that is easy swap if they are different. Also there may be a length issue on the upper tube linkage housing so you may have to swap that over too - hopefully that is not the area your existing one is cobbled.
I think you may have what you need to make this work.
FWIW: A decent handheld rpm tachometer to get the low idle, high idle linkage adjustments all correct would be benficial IMOP. Even an old school handheld friction type tach can be used on the PTO shaft with creativity if you know the PTO speed of each setting (in the archives). Alternatively, a cheap modern photo eye type ($20) can be used on the engine directly and no need for the PTO math.
DSlater will hopefully be along shortly to correct anything I forgot...
This post was edited by rankrank1 at 15:38:59 03/21/15 5 times.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
