Posted by Zachary Hoyt on March 13, 2015 at 06:49:49 from (74.47.51.2):
This spring and summer I plan to replace a poorly built pole barn with a real building. I asked a year ago about the concrete piers I was planning to use and was given some good advice about them including the name of the shape in the thread at the link below. Basically they will be a tapered footing 22x22" on the bottom and 8x8" on the top and 5' tall, set 4' in the ground. I am now wondering about reinforcement for these piers and have been doing some research without finding out anything very definitive. There is no code here for agricultural buildings so I don't have to worry about that, just about what will actually work well. I have three older books on concrete but none addresses this situation and online information has been contradictory. There will be 20 of these piers in a 28x48 small barn-type building with a loft. I am thinking of using 4 lengths of #4 rebar per pier, roughly paralleling the four corners about 4" inside the concrete and coming together at the top. Then I could set an anchor bolt in the top of each pier to fasten the 8x8 posts on. I am wondering if this seems reasonable and what I would need to tie the rebars together lower down in the pier. I could make a square or a ring out of rebar or I could just use some wire to hold them while the concrete is poured. Any advice will be much appreciated. Zach
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
