Posted by Bryce Frazier on February 25, 2015 at 07:01:07 from (67.142.182.25):
Alright, so I have been looking for a wide front for my Farmall H. After some research, I don't want an IH one, I want a Schwartz, Norden, ???
SO, I just had the wild thought a minute ago, I HAVE a Schwartz wide front, however it is on an Allis Chalmers WC!
The tractor is pretty much trashed, but the wide front is just fine except for missing a tie rod, but I could probably make one of those...
So, the tag on it says "Universal Tractor Front End" and then below it, it says Manufactured by Schwartz.
What are the odds that this would fit on my Farmall H? If it is "Universal" is it the wide front that is, but the mouting equipment is different, or is it a "Universal" for AC stuff?
What do you guys think? Time to whip out the tape measure?! :)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.