Good luck. Last I knew Ford still offers manual ("standard") tranmissions in 150/250's with gas engines. I don't know of any that offer a manual tranny with a diesel. Of course, I have never been in the market for a new vehicle, and won't start, even should I win the Lottery.
Consumer Reports said back in the '90's, that the best anti-theft device in a new car (other than in high-end sports cars) was a manual transmission - few ordinary people know how to drive one, and there is little call for them on the black market.
That was then. Now, even fewer people have the schmartz to use one properly, even if they can figure out how to use one at all. Manufacturers seem hesitant to put them in, not only because sales numbers are so low, but because they're afraid of warranty issues when someone beats up syncros, or tears up a clutch, or drive axle(s). That sort of damage is nearly impossible when there is slush between engine and wheels, and the computer controlling the automatic can limit torque.
Gotta admit, it's brain dead easier to back up a heavy trailer with an automatic than a standard. Fortunately, I'm not brain dead, yet, so I'll keep my sticks.
(ETA: too many interruptions from start to finish in this post)
Nice to see that that there are a few (de-rated) diesels with standards.
JFTR, with about 2 million miles over several vehicles, I've never had to replace a clutch or rebuild a tranny. Last one was ~260k on the original clutch, in a minivan that often hauled over a ton (firewood or a Super A w/ implements) on a trailer.
This post was edited by WellWorn at 19:52:48 02/02/15.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
