Posted by Chris Jones on January 31, 2015 at 11:49:59 from (65.188.217.236):
I know it's been discussed before. What's the cheapest way to heat--thinking intermittent shop heating. I was rechecking the calculations I made a few years ago with today's pricing and found the site linked below. Insert your cost and you've got your answer. Note the electric cost they refer to is electric resistance heat--not heatpump (air or ground source etc) as you'd get more BTU per KWH with them but how much depends on the efficiency of the unit and the air/soil temps.
Of course you have to think of the other issues like return on investment if purchasing new equipment, ease of use, and other issues. For me thinking of heating my shop: * I don't have access to Natural Gas. * Best I can run w/o purchasing a new heater and installing additional wiring is 3 - 1500 watt electric heaters simultaneously. * As for propane I'd need to purchase a shop heater as well and then either plumb it to my fireplace tank or buy and use refillable tanks. * I have a 10,500 BTU kerosene heater. * They don't mention wood but then I don't have a wood stove.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
