Posted by Janicholson on January 16, 2015 at 19:35:59 from (74.60.94.18):
In Reply to: I set the valves.... posted by BenH97 on January 16, 2015 at 18:02:21:
Backfiring is caused by the following: Combustion fire leaking out of the cylinder into the intake manifold. Caused by intake valve/s not seating (leaking), or not being adjusted even close to correctly. An exhaust valve not opening causing combustion issues including fire to sporadically be introduced into the intake because it was not expelled through the exhaust. Spark incorrectly getting to a spark plug when that cylinder is on the intake stroke. This results in combustion of intake mixture in the manifold and carb. Common reasons are plug wires in incorrect distributor location/s (cross wired). Cracks and carbon tracks in the distributor cap, causing spark to go where it is not intended. Also can be from a bad wire that forces radical high voltage, which then forces voltage to jump where it degrades the material of the cap. Wires leading to plugs being too close together and of poor insulation value allowing cross sparking. Excess fuel in the exhaust system (rich mixtures, failure to ignite a mixture in the cylinder then pushing it into the exhaust, and decelerating the engine allowing high vacuum to pull fuel into the cylinder too thin to burn, but still able to concentrate enough to explode in the exhaust as a spark from carbon or still burning fuel from a opening exhaust valve ignites it) The last one in parenthesis is pretty normal and common in vehicles with carburetors without electronic fuel shutoff on deceleration. A blown head gasket between two adjacent cylinders can also present flame to a fuel filled cylinder with the intake valve open. The above is the best thinking I have on this. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
