Posted by fixerupper on January 07, 2015 at 18:26:54 from (100.42.82.100):
OK, after the holidays I got busy on the Dodge cab, or as busy as I can be. Seems like I can get the most uninterrupted work done after supper. I am not an experienced body man by any means so I have to go slow so and learn as I go. Every replacement panel I got for it has had to be modified except for the cab corner. So far the only mistake I've made that I know of is cutting out too much of the hump beside the gear shift. A piece of filler tin will have to cover the gap. Thank goodness it will be covered with carpet when I'm done.
As you can see the two floor panels are held in with sheet metal screws for fitting purposes. How should I weld it? Stitch? Drill holes and imitate spot welding? Weld solid?
Whadda ya say?
This will be a work pickup when I'm done but I'm a bit of a perfectionist so I want it looking as close to unaltered as it can be.
This post was edited by fixerupper at 18:30:27 01/07/15.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.