jocco, A neighbor and I both have 20 ft Gooseneck Flat beds that we are putting new Floors in. The choice of wood is your biz. But think pressure treated will work fine. The cross-members are already recessed to accept a 1.5 in board thickness. The problem is all the Screws the Bed Company (OM) used to fasten the wood to the bed! Like on my Trailer they are a V-head and counter sunk into the wood. the real problem is that the treads will be rusted to the cross-members little to no chance to get them out cleanly! Get the wood out as best as possible, Grind off the screws. Cut the new wood and fit it as tight as possible. Here is where I would differ from the O.M. Put new wood in place, get 2 or 3, Of 2 or 3 in wide strap metal and tack in one at the front and rear of bed to hold the wood in place and one a t the 1/2 way point to prevent bounce! If wood ever needs to be replaced, a clean cut of the welds with a 4 in cut-off wheel and you are good to go, replace all wood put the strap back in place and reweld ! Done This is how My Neighbor and I will refasten the new wood to our trailers! To do metal you will need to cut and fit new Cross-members to support the steel deck and you may need to add additional cross-members in the splits to stiffen the floor up depending on the width of the original splits! then weld in permanent! Hope this helps Later, John A.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.