Posted by racsan on December 22, 2014 at 16:47:07 from (184.57.98.47):
In Reply to: Because I still can posted by Dan in Ohio on December 21, 2014 at 07:03:37:
I heat with wood, sure there is work involved but the only other way to heat the house is the fuel-oil furnace, while there is some fuel in the tank, id much rather go with wood and not have the big expence of filling that big tank every so often, ive got a good stockpile built up and i still cut when its nice, cause you never know when it will be too bad out to cut. The stove is a tough old lilly, has a blower, they dont make them anymore, but when they built these they were built to last. I burn a cresote cleaning log every so often, have a bucket on the stack in the summer to keep the birds and rain out. Have plenty of wood along the property line fence rows to supply what i need, usually drag the trees to the barn with the 1020 or the A (now that its back in service) and process it closer to the house. Even if fuel oil was cheap id still go to the effort of burning wood, after all..... I can.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.