Posted by rankrank1 on December 21, 2014 at 09:44:44 from (166.137.14.59):
In Reply to: Because I still can posted by Dan in Ohio on December 21, 2014 at 07:03:37:
Dan,
I like that outdoor stove you have. If I was ever going to consider using wood for heat then an outdoor stove something like yours is the only way I would go. Course they are pricey.
Outdoor stove at least keeps the mess and smoke totally outdoors. Wood done wrong can be a dirty nasty heat when using an indoor stove for people with breathing problems. Ever go in peoples home and the walls and ceilings are all smoked up - yuk.
I personally do not enjoy cutting wood so I doubt that I ever will go that route especially since I have no free source of obtaining it. Plus I am with JD Seller on wood is not always as cheap as people think it to be. Quality saws, splitters, and most importantly the time to do it. Last thing I want to be doing with what little free time I have is cutting wood. Kudos to those who enjoy it though.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.