2" pvc tube about 15" long, one cap jammed on the one side with a hole drilled in it about 1.5 inches for rat. I use 1" for voles. The other end, use a belt sander and sand down about 2" of the end so that the other cap fits easily. Drill a hole through the cap and pvc pipe so that you can run a wire through it. fill with poison blocks, put the drilled cap back on and wire it so that the end cap doesn't come off. Put it somewhere where you can wire it to something. The problem with rats as I see it, the larger hole, 1.5" may allow the poison block to fall out. the other thing you an do is get a 5 gallon pail, fill it half way with water and put a dowel through the top and a metal sleeve. Use peanut butter for bait. Make a little ladder for them to climb up , walk out on the sleeve to the bait, the sleeve turns, and dumps them in the water, they drown.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.