Posted by piotrl on November 29, 2014 at 15:38:31 from (209.155.109.250):
I am new to owning a tractor, and I have a problem with my Ford 8N tractor.
The problem is it's not starting. Starter has been replaced. Old fuel bowl had the mesh that appears to be dirty and might not have been allowing fuel to flow through. New fuel bowl has been installed. The tractor would not start. I was told that leaving the fuel bowl valve on flooded the carburetor. I shut it off and drained the carburetor. A week later I started it and it ran for 3 minutes. Then it died again. I was told that the fuel valve must only be open about 1/4 of a turn in the fuel bowl. I shut it off, drained carburetor, and let it sit for a week. The tractor will not start if I have the valve open only 1/4 of a turn or a little more. What could be the problem with it not starting or what should I try?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.