Posted by old-9 on November 17, 2014 at 16:53:24 from (67.236.68.212):
In Reply to: todays rant! posted by jon f mn on November 17, 2014 at 08:06:08:
Good topic jon. Idon't drive big trucks however my son drives tri and quad axel dumptrucks. He finds himself running with the same trucks alot , one "driver" used to play with him, driving at a lower speed then speeding up when my son was trying to pass, he had more motor. After several times ,son found himself behind the jerk at the pit one morning. He pulled his fronts halfway on the scales putting the jerk overweight. So jerk had to go dump off and rescale,now under weight, add more gravel.Later ,on CB, son let him know what happened. Seemed to help, no longer messing with him. As to running the same speed , tailgaters are my pet peeve, I drive the wife crazy (short trip) when I keep slowing down untill they pass. Keep on trucking, joe
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.