Actually a GFCI trips by sensing a CURRENT (NOT voltage as stated) DIFFERENCE in the Hot Ungrounded Line conductor "current" and the Neutral Grounded Conductor "current". There's a torroidal coil encircling the Line and Neutral and as some know current passing through a coil induces a voltage. HOWEVER if the incoming line and outgoing neutral currents are the same they cancel, so there's zero net current so no voltage gets induced into the torroidal coil. ITS THE "CURRENT" not Voltage DIFFERENCE (Hot and Neutral) THAT TRIPS A GFCI........
HOWEVER if theres a fault leakage whereby all the current flowing in the hot is NOT all being returned by the Neutral the current difference (something like 5 milliamps) sends a signal which trips the GFCI breaker.
NOW BOTH the metallic receptacle or junction box PLUS the green grounding terminal on the GFCI (or any) receptacle must be grounded.
Sooooooooo if the GFCI trips by connecting its Grounding receptacle to the Box THERE MUST BE A FAULT/SHORT by which some current flowing in the hot isn't all being returned by the Neutral.
Soooooooooo where's that short/fault?? Maybe a wire has bad or stripped insulation and is touching the metal box?????????? I think I would check all the wires coming into and exiting that box as well as the circuit that goes to that box or exits it..The fault circuit isn't completed until the box comes into the equation.
Other problems such as mixing and matching or crossing Neutrals and Equipment Grounds can come into play, but Id start looking at that box and all its wiring first. Have one of those three prong testers that verifies proper wiring???
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.