Posted by Steve@Advance on October 25, 2014 at 20:11:59 from (107.203.134.67):
In Reply to: deutz dx160 posted by rummm64 on October 25, 2014 at 18:15:27:
Have you checked the voltage on the "bat" side of the ignition switch? Could be the power isn't making it to the ignition switch. Just a matter of tracing it back.
You're not looking for a "short", that would be a wire going to ground. You're looking for "high resistance", a bad connection. Not likely to be in the middle of a wire, but at a connection, like a corroded end connector, a plug together connection, etc. Look for heat discolored, melted plastic, green stuff growing out of a connector... Might want to go at it from the battery end, see where the incoming power from the battery goes, should go to a power distribution block, branch off to various components. You are on the right track checking for voltage drop under load.
I'm assuming the starter is probably a Delco (or similar) with the plunger type solenoid on top of the starter. Those solenoids draw a lot of current, therefore expect to see some voltage drop. Even when everything is right you're still reading the resistance of the wire, so the farther from the battery you get, the more drop you'll read.
This is a common problem with those type starters. Why did it work for ever then decide to start acting up? A mystery of the universe... A solution is to mount a Ford type solenoid down close to the starter (which requires much less current to actuate). Use the wire from the neutral switch to pull in the Ford solenoid, connect the power lugs with 10ga wire from the battery terminal on the starter, back to the terminal where the original start wire was. Should solve the problem.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.