Ihave heavy mats in my stock trailer and I cut them to fit in the trailer. and two sit side by side in it. As i recall they are 3-1/2" x 5". so their are four setsI drilleled holes in one end of them and threaded havy baler twine through the holes and thenthrough a couple of 1/4" wahers and knotted the twine. I use these for handles to pull the mats out. (I"m sure are other ways of doing this but that"s what I elected to do.)
When hauling stock (cows and/or calves), I put about 6 inches of saw dust, shavings, or wood chips from leocal mill down. When I"m done with the haul, I then shovel the manure and chips into the compost pile or the blueberry patch, pull the mats and hose them off and clean the inside of the trailer. The trailer is 16 years old and there is no sign of rot in the treated floors and very little rust or corrosion.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
