Posted by andy r on October 14, 2014 at 21:30:07 from (75.91.149.15):
I have a fairly nice 18 foot grain bin (Butler) that I modernized on a new foundation. Added an aeration floor, fan, and unload auger. Originally the bin was 6 and one-half rings high. Didn't use the one-half ring, but did add one more full ring to make the bin seven rings high. The bottom ring is basically the same gauge as the 2nd from the bottom ring. The bottom two rings are made up of pieces that weigh about 70 pounds each (six per ring). As you go up the pieces weigh less. Most say I do not need to add stiffeners (two per section of ring - 12 total around the bin) if I am putting dry corn in the bin. They say the rings give way because higher moisture corn sticks to the side and then settles pulling down on the side causing the sheets to crush down. Corn going in will be dry - 14.5 percent. I have a similar bin, 7 rings high and it does fine. The problem is I don't know if it has heavier sheets at the bottom. I can still put stiffeners on and would probably only need to go a couple rings high. If dry corn and/or beans are OK then it would be over kill. Ideas would be appreciated. Thanks.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
