In 1970, my dad bought a new Chevy CST 1/2 ton truck. Hugger orange and white. Beautiful truck with many problems.
After warranty expired, I replaced the starter three more times in 50K miles. The truck wouldn't start good unless he had a really high amp battery.
Then the flywheel was damaged/worn.
I went to the same dealer he bought the truck from and purchased a flywheel.
Parts manager was a personal friend and during my discussion he requested the engine number.
I called dad and he gave me the number.
Parts manager said the engine had been changed???
I assured him we had not changed the engine and he stated it had a CORVETTE engine!!
I asked him how could that be because it was not evident from outside engine.
He suggested that truck line may have ran out of truck engines and they just pulled a few from corvette line???
He sold me a different starter and flywheel and the starter problem ended. I have no idea why the truck had a corvette engine or how many others got the same type engine or why all external components--valve covers etc.-- were same as other trucks.
I checked the compression and to the best of my knowledge, been a long time, it had a lot more then other 350s I had worked on.
Another problem was with motor mounts. Don't remember how many left motor mounts we replaced before GM sent dad a recall and they installed a cable mounted to the exhaust manifold bolts and wrapped around frame.
"Excellent repair" that actually worked if you could put up with buzzing vibration during heavy throttle!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.