Posted by T in NE on October 05, 2014 at 07:32:51 from (75.238.91.129):
In Reply to: john deere dealers posted by Nick167 on October 04, 2014 at 10:41:26:
Titan bought out Curly Olney's a couple years ago. We were hoping that service would improve, the boss would like to move to more red equipment, but it hasn't. If you want someone who really knows what they're up to you need to make a road service call. Was talking to someone whose son was washing machines for them. Came in one day and asked who they hired, there was a new toolbox there. "It's yours, you're a mechanic now".
Crank sensor went bad on the Steiger during planting, caused a bunch of shift problems. The mechanic showed up with an empty service truck. Had a screwdriver, couple wrenches, and a few inches of emery cloth with him. And no manual.
Call Plains for a JD problem, might take a couple hours to get there the first week of picking corn or planting, but they show up with a fully equipped service truck, with a laptop loaded with all manuals.
They may not have all parts on the shelf (like the pressure relief valves that all 1770 planters use) but they have most. They robbed one out of a new planter a couple years ago to get me rolling again.
Heard someone bought the NH franchise off the dealer in McCook. That would be good. They have almost 0 shop space, and looking up a part number can be pretty strenuous.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.