Recently my 20 hp command engine had a mag problem. When I turn it off, only one coil shuts off. Well I thought I replaced the mag coil causing the issue, wrong. So I replaced the coil wires, even one coil, and come to find out it's the other coil. That said, I turn my engine off with the solenoid on engine. My engine won't run for 5 seconds with no power to solenoid.
I blew a fuse once and discovered just how fast engine stops.
I have a 14 hp single cylinder kohler on an old crapsman mower. The solenoid went out. I went to town to buy a new one and the parts store said I would have to go to sears to buy it. Well Bubba suggested that I wedge a small paper clip in solenoid to hold jet open. Bubba was right, it been working without a solenoid for about 7 years.
I asked why have a solenoid? Parts guy said it was to prevent dieseling when engine shuts off. I can tell you, the solenoid doesn't prevent dieseling. Adding E85 to gas does. I'm currently making my own E20 blend, so far with great results, no side effects like carb, gas hose or fuel pump issues. However it could happen and there are some who HATE me so saying ethanol does have some good properties.
I recently bought a used 18 hp command off a cub cadet. Got it off craigslist. It has an older carb with adjustments. Was planning to use it on my 20 hp to lean down the fuel mix. So far, I may not, waiting to see what winter brings. I'm guessing I may have to keep what I have and reduce E blend.
Someone on YT gave me this link to kohler, I downloaded a service manual, found it to be very helpful, hope it helps you. Good luck
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.