Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Tractor Talk Discussion Board

Re: OT Kohler 18HP Command Engine Question


[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]

Posted by George Marsh on September 29, 2014 at 15:16:33 from (50.104.98.200):

In Reply to: OT Kohler 18HP Command Engine Question posted by John B. on September 29, 2014 at 09:55:24:

I recently purchased a used 18 hp kohler command horizontal shaft off a Cub Cadet. Only paid $35 for it. I purchased it because it has an old style carb with adjustments. My 20 hp command has fixed jets. A kohler coil costs $50, so I feel like I got a bargain, 2 coils, carb and starter.

That said, my 20 hp command has no timing. The magnets on flywheel are in a fixed position and the coils go in a fixed place. No timing. I use 3 one dollar bills to space coil above magnets before I tighten the coil in place.

One thing I've learned about the kohler carb is there are 3 tiny vent holes on the top part of carb. They must be kept clean or the engine will run rich. I use 30 psi of air and blow each vent hole out and you will see a stream of gas come out holes above throttle plate.

The used engine I purchased didn't had 300 hours on it. The engine was used is a dirty environment on the Cub cadet. The owner said the engine overheated and he junked it out. WOW, over heated and 100% blockage in head cooling fines. Go figure a Kohler earns a bad reputation for not lasting 300 hours when the IDIOT didn't take care of it. I have 1500+ hours on my Kohler, use no oil, never had heads taken off, done anything except preventive maintance.

If any engine doesn't get enough gas, it won't make power, just that simple. However if it gets too much gas it won't work right either. Look at spark plugs, if black with carbon, too much gas. My experience is that a lean engine will run just fine until it's put under load. It takes gas to feed the all horses. Check air filter, gas filter and you may have to take carb apart to check for any blockages. You may have too low of float level or the governor is set to respond too fast, carb can't keep up. Good luck.
George


Replies:




Add a Reply!
You must be Logged In to Post


:
:
:

:

:

:

:

:

:

Advanced Posting Options

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.



 
Advanced Posting Tools
  Upload Photo  Select Gallery Photo  Attach Serial No List 
Return to Post 

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend. ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy