Posted by Steve@Advance on September 20, 2014 at 20:32:28 from (107.203.134.67):
In Reply to: TO-20 posted by spudm on September 20, 2014 at 19:18:46:
Before going in after the rear main leak... First be sure it is engine oil, could be transmission oil. Either would drain out the same place. Transmission seal is much easier to replace, but still requires splitting the tractor.
Back to the engine seal, a couple of things to check.
Be sure the oil is not overfull.
Be sure the oil isn't coming from above and draining down from the valve cover or the oil pressure gauge line.
Check the crankcase vent, be sure it isn't clogged.
How is the rest of the engine's health? Good oil pressure? Blowby? Deep engine knocks, especially on cold start up or heavy load?
A badly leaking rear seal can sometimes be a symptom of a more serious problem. If there are other problems, the seal will fail again. Might run it awhile, see how things look. If no other problem arise might want to try a rear seal. It's a rope seal, it may have been improperly done previously, especially if the engine has recently been gone through.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.