Posted by jon f mn on September 11, 2014 at 20:00:04 from (65.128.249.174):
Stopped by Jeff's house today and he asked if I could fix his manure spreader axle. Done a few of these over the years, they are not fun but not hard. Sure wish he woulda cleaned it up a bit better before he put it in front of the shed tho. Lol. Oh well, it could be worse, at least it's not a liquid tanker.
I got the old axle out and the spindles removed and mostly cleaned up before I ran out of grinder wheels.
Found an old plow beam for the axle and got it cut and almost ready to weld before it started raining again. Cut it to square the end, then saw that the cut was too close to the holes so had to recut it. Oh well, not my first mistake and it might not be my last.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.