Dad's been getting the feed for a couple years now. The barrels have holes drilled in the bottoms to drain out some to help them loose weight. During the summer he leaves them outside and dumps them into the loader bucket, and then dumps that on top of the silage before taking a scoop from the bag. Mixes in pretty good, but most of the girls really like it as it is as well.
In the winter it's a little more work because they bring them in the barn to keep from freezing solid in the barrels. Normally scoop it out with a pail and feed it on top
of the silage as it's fed.
I will say the girls seem to have gone up some on milk, and the way they eat it dad will be getting it for as long as he can. They like dad down at the brewery because he'll come if they need some empty barrels provided they give him an hour or 3 lead time so he can make sure to dump a few out. Other guys they had were driving farther and much slower at turn around with a barrel of it.
The dock they have is basically an extension of they're wooden deck (they also have a restaurant) and the parking lot is kinda bowl shaped, so they already havea large concrete slab on one side just to level out the trucks. Adding another ramp to that would get kinda hairy in my mind. Going to the trailer isn't so bad because gravity helps him get them down to the trailer.
If he could afford one,a dump trailer would certainly be nice, but I really don't think they'd want it outside and there is no where inside to park it either. A dump bed on a running gear would be a no go as it's tight enough backing a trailer sometimes with the way some people park. Even hit an employee's car after warning him several times that it was a bad place because he needed to swing in there.
Food for thought right now and not all suggestions are impractical. Would just take some figuring on the brewery's end as to how to move it as well.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
