The fuel may be cheap, but the engines are not. Once you realize that most of the purchase cost of a piece of machinery is determined by the materials which go into it, it becomes apparent that steam engines (the boilers, specifically) are very expensive. A 20 hp steam engine will likely weigh in excess of 5000 lbs empty, while a 1950's 20 hp gas tractor can easily weigh less than 2500 lbs. That is a 2-to-1 cost difference in materials alone. Also, maintenance is a major problem when you have open mechanisms which are exposed to lots of water and dirt, while being only marginally lubricated. Plus, you have no instant performance. First you must warm the thing up and start to make steam, then you must anticipate load by adding fuel at the proper rate. Too little fuel and the pressure drops, and too much fuel causes the pressure relief valve to blow, wasting a bunch of stored energy that you just fed into the firebox. Poor efficiency is another issue. When you have a lot of surface area, you have a lot of area that can transfer heat. With an uninsulated boiler like the ones on vintage steam engines, you are constantly loosing gobs of heat to the surrounding air. With this style simple boiler you are lucky to get 15% efficiency out of the fuel you burn. Almost any old gas tractor will give you 25% efficiency when working at rated load. Then there is the work that is required to feed it. Steam tractors need lots of two things to operate; fuel and water. Anyone who has a wood stove knows the constant work that is required to keep it going. Now figure that your wood stove has more than 10 times the appetite, and that it is also constantly leaking a few gallons of water each minute. Now you have an idea of how much work it is to feed a small steam tractor that is working.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.