Posted by SDE on August 24, 2014 at 07:58:31 from (184.157.216.215):
My hydraulic jack is too tall, so I lift the vehicles with a screw type scissors jack and then put the hyd. bottle jack under it and finish lifting it. When I lowered the vehicle on to the jack stand, it rolled back a little. I then put blocks behind the rear tires. I finished the job, raise the vehicle, pulled the jack stand out and then saw that hyd. jack was barely under the frame. I put the jack stand back under it and pulled the screw jack out from the side of the vehicle. As I started to lower it, the jack kicked out and the vehicle fell onto the jack stand. Yes, I made a few mistakes. But that is why I posted this. To point out how quick and easy it is for us to get hurt. Be careful out there SDE
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.