The 2x2 square tube along side the engine will break...look at used loaders and you"ll see where they have been welded/reinforced. Very common. Recently saw a loader on craigslist where the owner said it"s welded in the usual place.
Other major issue is the rear engine mtg bolts will break....you will see the muffler move opposite of the hood, making you think you are seeing things. The bolts are covered up by the side frames...take the frame off and you"ll see the broken bolts. They can be drilled/tapped larger, once. Then replace the engine block, or weld the bolts in place. I"ve seen it done, and dealers told me about switching good blocks to get new mtg holes.
Reason for the problem is that 3010/3020 tractors have only two rear engine mount bolts. 4010/4020 have four bolts. Entire loader hangs on the side frames of the tractor.
My solution? I added reinforced 4 inch channel, extending the frame back to the rear axle, so push energy goes to the axle, not side frames. Haven"t broken anything since.....had the loader since 1977? Did the mods in late 80s?
Changed hubs to 4020 style- they are heavier, about an inch thick entire circle, not just where bolts are. Pics are in archives here. My mod also gives a nice step to access the tractor.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.