Posted by Bill420U on August 11, 2014 at 09:22:07 from (173.62.215.113):
I have a John Deere 750 tractor with an after market Bush Hog loader. The loader utilizes a joystick which has 3 hydraulic lines connected to the tractor’s hydraulic system: IN, OUT and Power Beyond (PB). The OUT hose goes to the reservoir, The IN hose goes to the O port of the hydraulic pump and the PB hose goes to the I port. I understand that this is a closed center system.
When I want to use my 3point log splitter, I disconnect the loader’s PB and IN hoses from the tractor’s hydraulic system and connect the splitter’s IN and OUT hoses respectively to the I port and O ports of the tractor’s hydraulic system.
This gets to be a PITA whenever I want to switch between the loader and log splitter because I have to disconnect and reconnect hoses. It’s additionally harder because reconnecting one of the loader hoses meets a lot of resistance due to some unrelieved pressure. So I thought about setting up remote outlets where one only has to connect the log splitter’s hoses and leave the loader hoses alone.
How is this done? What do I need to do to accomplish this? Do I route the loader’s PB hose to one outlet where the splitter’s I hose would hookup. And the splitter’s O hose would be connected to the other outlet which in turn connects to the O port of the tractor’s hydraulic system. Then put a plug in the tractor’s I port. Would this work?
If it makes a difference, the PB hose and the splitter’s I hose have male fittings; the others are female.
I hope my description of the problem is not too confusing. I know little about hydraulics but am mechanically capable.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
