The last owner put the 3-sided pto shaft together wrong. As you may know, 3-sided shafts only go together one way; you have to line them up correctly. This has to be done by looking at the shaft ends & seeing that two corners are one shape & the third corner must match up with the 3rd corner of the other half of the shaft. I bought the tractor with 'hog attached. Sold the tractor & kept the 'hog. Tried to put the 'hog on another tractor but the pto shaft wouldn't slide. Suspended it by the yoke off the ground for 24 hours, then beat the yoke with sledge; didn't move. Lowered the 'hog to the ground & pulled chain tight & beat on yoke/chain. Had to beat til only quarter inch held the halves together, then it came. No rust whatsoever, just old grease the whole length. The former owner or his helpers had driven the mismatched halves together! Lined up the shaft ends correctly & slid together easily. Some people should not be near a farm.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
