Posted by willie in mn on August 04, 2014 at 12:38:31 from (64.12.116.16):
In Reply to: Efficiancy of Labor posted by fergienewbee on August 04, 2014 at 06:42:54:
Larry I have always been in favor of saving manual labor. Many times a little planning, a small investment in equipment & alittle prep work saves a lot in tired, sore backs. Some parts of my system will work for you, some might not. Adjust as needed. If your tractor can't lift a full pallet/cage, make them a bit smaller etc. Planning- How close to the burn point (stove) can you get with the tractor, is the wood used in chunk size, does it have to be split? How big a load can the carryall handle? Investment- can you find a fork lift attachment for the tractor 3 point hitch, or can the carryall be modified to handle pallets, can you get pallets cheap or free? Prep work- build several 3 sided cages on pallets, leaving the longer side open(don't have to reach so far when loading). If using a splitter, fabricate catch tables so the wood doesn't fall to the ground. Operation-Set a cage as close to the cutting/splitting point as comfortable. Stack wood into cage directly from splitter. When full, start another one. When finished cutting/splitting, Using the forks, move the cages to storage area, let them sit. Pick up a cage & move to stove area as needed. Again, let the cage sit until wood used up. Using this method, after the wood is cut/split, you have handled it only once & it is right where you need it. Also, being on pallets, it is off the ground so it doesn't draw moisture & can get air circulation for better seasoning. Use your imagination. I have a couple neighbors that burn a lot of wood, they help each other. Going one step farther,they use the Bobcat to lift logs onto a rack, do all the hard work standing up straight instead of bending to the ground. Hope this is worth more than you paid for it. Willie
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
