Posted by Steve@Advance on July 26, 2014 at 11:24:42 from (108.245.66.82):
In Reply to: JD 970 fuel gauge posted by Tony Tee. on July 26, 2014 at 09:49:11:
Need to test the circuit to find the problem.
First, give it a visual inspection, look for pinched, chewed, cut wires. Be sure the tank and sending unit are grounded to the chassis.
Disconnect the wire from the sending unit, see if the gauge falls to empty. If it does, the problem is in the sending unit.
If it stays on full with the wire disconnected, ground the wire and see if the gauge goes to empty. (Some work backward, just need to check to be sure.) If it does, the problem is in the sender.
If removing and/or grounding the wire make no difference, go to the back of the gauge and remove the sending unit wire (Not the power wire). If the gauge falls to empty, the wire is shorted to ground somewhere.
If it stays on full with the wire disconnected, the gauge itself is bad.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
