The CRP contract is a lease, and just like any other lease the buyer is stuck with the terms of the original contract to which the seller signed.
As to who gets the PAYMENT, that depends on the sales contract between the buyer and seller. Normally the buyer gets the payment, but they can assign it back to the seller. The buyer and seller need to fill out a form with FSA to assign the payment. I went through this a couple of years ago when we sold some property that had a year left on the CRP contract. The buyer gave us the last year's CRP payment to sweeten the deal.
If you have a payment assigned to you and you don't receive the payment when you expect it, follow up! In our case, the local FSA office messed up and the payment reassignments didn't get processed so the payment went to the buyer. He sent us a check when we figured out what happened.
Now in our case it was only one year's rent, and we knew and trusted the buyer. Under no circumstances would I want to have the payment reassigned back to me if I was selling property that had five years left on the CRP lease! Think about it: the buyer has zero motivation to abide by the lease. He might run cattle on the property, or break it up to plant crops. What then? You won't get your payment, and the cost of taking the buyer to court might well be more than the amount of the lost payments.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.