I started working on Small Engines in about 1975 . I have worked in Good Shops & have worked in Bad ones . When I retired from the Service in 1978 I wanted to open my own shop but the Wife said NO , She said that if someone came in a gave a Sad story that I would just tell them to take the Item .She said she wasn t going to Support the free loaders . Out here in AZ, a lot of the Shops charge $65.00 & up an Hr. I still work on them if someone wants me too , but I always check it over & call with an estimate . I don t change anything that it doesn t need . Save all the old parts for the Customer , Charge about a third of what the Shops charge . I always tell them that I am not trying to get rich but the work I enjoy & relaxes me . I don t work on anything big as I don t have the room . Everyone that I have repaired for people are Pleased with my work & send others to me . Must be doing Something right . John In AZ. flakyfriends2@cox.net I have several commercial people ask me what they could to keep their machines out working instead of the Shop , I told them to get an air compressor & keep the trash blown off . they just didn t get it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.