Posted by JRSutton on July 10, 2014 at 04:09:08 from (71.174.108.252):
In Reply to: Re: NH 68 Picture! posted by Bryce Frazier on July 09, 2014 at 18:07:25:
Bryce - a couple of things you may or may not know - just picking up on things you typed here.
All you need is an overrun clutch and a pto shaft and you can run your baler by pto (probably want to pull the belts off, but may not HAVE to). The clutch just screws right to the flywheel.
The pto shaft has a bracket that mounts to the tongue of the baler... if you look at a picture of one, it'll be obvious.
I've got the whole clutch/shaft assembly, but unfortunately just promised it to somebody a few weeks ago. Otherwise I'd send it to you to play with.
Another thing - you'll rock less using the wisconsin engine. When you're running it with PTO, that'll put a sort of repetitive load on the tractor, adding to the sea-sick feel. I'm sure on a C you'd feel it pretty good.
And last - you said you were in 1st gear at idle... makes me think you weren't running the wisconsin engine at top speed like you should be.
Maybe somebody else can chime in here because I can't remember the number - but they always rated those old balers in strokes per minute. I can almost guarantee you won't naturally open up an engine that fast and hard on your own to get the baler up to the right speed.
But if you count the plunger strokes, you'll find you've really got to crank that little engine for all it's worth.
Running at the right speed, you'll be able to move around better, probably in 2nd gear with no trouble. Depends on the hay and windrow size of course, but the baler speed really makes a BIG difference in performance. You might even see the bales come out a little more consistent, but I'm not sure about that.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.