Would seem to work fine, add a little more portland, and if your gravel is a composite mixture of aggregate, not just straight up crushed stone, that should give you the array of aggregate needed, its usually, various sizes passing through certain size sieves, still should work fine, but if its one size crushed stone, (as I realize different areas use the same terms for things but have different meanings) maybe you can get an intermediate size aggregate in there?
Either or, should work with the right amount of portland, just be careful with how much water you add, that's the biggest mistake usually, not having the water/cementitious material ratio right, people tend to add too much usually on the water side to make the material more workable. can't be your first time mixing this anyway, most usually have an eye for the slump they want, I always did with mortar, same thing with concrete, and if I did do that I'd "tighten" it up with a little more portland anyway.
The only thing I think can be difficult, with small batches, too small to order a ready mix truck, but big enough where you have to mix several batches, is keeping the mix uniform, and or more importantly, keeping enough material flowing. I liked to mix my own for small jobs too, but seems in the summer time, it starts to cure sooner than you want it meaning you're still making material to fill the form, and you may need to be screeding, finishing etc. I did this little apron slab at a friends house years ago, bag mix and wheel barrow, too restricted to do it any other way, and we really went quick making the material, yet I still had to be very careful, one end of the form was setting up and was ready for the broom finish, had I been able to bring my mixer, different story, LOL was not wanting to do that one over, 19 bags carried down the steps, through the walkway, to the back, hot summer day, came out fine, and still looks good today.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
