To form a legally enforceable contract it requires (best I recall off the top of my head without researching so no warranty)
An Offer An Acceptance Consideration Capacity Legality
An Offer alone DOES NOT make a valid enforceable contract HOWEVER if an Offer is made and its Accepted and the other requirements are in place NOW WE HAVE A VALID LEGALLY ENFORCEABLE CONTRACT.
However as a practical matter as far as real estate sales contracts, A SELLER CAN BE FORCED BY LAW TO COMPLETE A HOME SALES CONTRACT, HOWEVER ITS A BIT TOUGH TO FORCE A PERSON TO BUY A HOME. Often if the buyer backs out the seller may retain the earnest money deposit.
AS I ALWAYS PREACH: Consult a local trained professional attorney and don't hang your hat on lay opinions offered on a tractor forum is my best advice.....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.