Remember Dad doing all 3 methods back in the 1950's
Check Row used a wire stretched across the field with special stake at each end that held the wire. Wire had a joint every 38 to 40" that would trip a mechanism on the planter and drop the seed kernels in a hill. Get to end of the field, release the wire, turn around, stop and move stake and hook wire back in trip mechanism.
The purpose of this method was to make rows both vertically and horizontally across the the field so that you could cross cultivate to get weeds out between the hills.
Hill dropping was similar but no wire. There was a cam on the planter that would trip the drop mechanism but did not maintain uniform spacing from row to row.
The above methods dropped two or 3 kernels in a hill. Drilling dropped single seeds at shorter intervals across the field. End rows were usually drilled.
I never ran the planter, but did spend many summer hours on a John Deere A or B with 2 row cultivator. Cultivate 2 rows, skip two until you got across the field and then do same coming back.
I'd get across the field, look across the road at the neighbor with his 4 row and realized if I had his 4 row, when I got across the field I could be home watching TV rather being only half done and working my way back.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
