Posted by Bryce Frazier on April 26, 2014 at 13:57:15 from (67.142.182.27):
Alright, so my neighbor finally broke down and bought a plow, it is a JD, 5 bottom, 16 trailed plow. I THINK it 3100?? But not sure...
It has three wheels, and is trailed, rather than semi mount...
They have never plowed with this type of setup, and have enlisted my "help"....
They THINK that their Ford 5000 is going to pull this thing around like it isn't even back there, I think that it MIGHT dink around with it, but that their 8000 would be a MUCH better choice!!
Sooo, either way, what ever tractor they end up using, when I hook up the plow, should I set it so that the tractors right wheels ride down in the furrow like all of the old tractors do, or should I set it so that both the left and right sets are up on un-plowed land?
I'll try to find a picture of what the plow looks like online, but I think you guys should get the picture good enough to answer the question!!! THANKS, Bryce
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.