Friend of mine was asked years ago to put "sides" in the flights of an auger that was hooked to a truck mounted frame and used for boring "test holes". Friend told the guy it wasn"t a good idea, but the guy insisted, and after all, money is money......Anyway, the truck the ring was mounted on was brand new, as was the other truck on the job side the day the incident happened. The "incident" consisted of the auger getting down quite a few feet and then them not being able to get it pulled back out due to the sides holding/packing the dirt to the auger flights. The result was that in their trying to get it turned out, instead of the auger turning, it spun the new truck it was mounted on into the other new truck. End result was two damaged trucks and quite a few feet of auger stuck, and left in the ground.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.