Posted by tedregentin on April 13, 2014 at 06:41:47 from (216.110.201.79):
I am working on installing a loader on a Moline 445. I had fabricate brackets to mount and install the loader. I have never done much with hydraulics, so I have questions. The loader uses a pump that runs off the PTO. How does the pump attach to the PTO? There is a hole in the pump inlet shaft that it appears as though a pin would go through the PTO to hold the pump to the shaft. Would I drill a hole through the PTO itself. Also, there is a bracket that bolts to the pump, that would hold the pump in place. What is the best way to secure the pump? There is a rectangular tank that bolts to the loader frame. Am I correct in assuming this to be the flow pattern? Fluid flows out the bottom of the tank through the spin on filter to the pump, out the pump to the inlet side of the control valve assembly and then the exhaust side of the control valve assembly goes back in to the top of the reservoir. The loader is off a fence row 3020, no tags, and I got this thing already disassembled. Thanks for any replies. Ted
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
