Posted by Paul on April 12, 2014 at 11:00:18 from (66.60.223.232):
In Reply to: Got 300 home posted by Bubbas Boys on April 12, 2014 at 04:11:13:
Replied at the other site, didnt see your message here.
Your hyd linkage must be messed up, open center hyd the pump always flows oil at almost no pressure until you move a lever.
So:
Either some hose is blocked within the hyd system.
The ports directing the extra flow of oil are plugged up.
Or your hyd valves are not set right, most likely. Jiggle those 2 hyd levers there on the right side.
Don't run it without hyd oil, your pump gets real unhappy real fast.....
Your power steering, if you have, runs off the same pump, was the power steering causing the problem? Just thought of this....
The add and check hole for the hyd oil is in front of the brake pedals, that angled little plug. Look in, it should be about full there. Anyhow we always about fill that hole up to the threads.
As I mentioned on the other site, check your independent pto also, that is a seperate resivor, don't be like me and forget.....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.