Posted by Chris Jones on April 07, 2014 at 16:44:13 from (71.71.58.79):
My fathers JD 850 had an vent tube for the transmission that comes up behind the seat and looks like and upside down J. Well somehow it's gotten broken off slightly below the surface of the case leaving an open hole into the transmission.
How can this be fixed?
1. can I use a slide hammer with a hook to reach down inside the tube remaining in the hole and pull it out?--I assume it was just press fitted. 2. Should I find a piece of tubing even smaller and fit it inside the piece still inside the hole? 3. Should we as he first suggested, tack weld it back? I said no because A. It's broke about 1/8" below the hole surface. B. The hole is cast iron and the tube steel. C. My 225 amp buzz box welder isn't a magic wand. 4. Should as he then said we just sit the broken piece over the hole and pile JB weld around it?--I don't have high hopes for that working for long. 5. Or lastly as he's probably just going to forget it, should I just leave the stick he stuck in the hole in there and forget it too? 6. Any other ideas?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.