Inflation was a big problem from the late 1960's into the early 1990's. The buildup for the Vietnam war overheated the US economy in the late 60's. In the early 1970's Nixon implemented a series of three or four "Phases" of price controls to try to slow inflation. The 1973 oil embargo rocketed oil from $2/barrel to close to $10. The price of alternatives like coal and natural gas also went up accordingly. As the prices of inputs went up, so did the price of most manufactured goods.
In the mid 1970's the US faced "Stag-flation": Stagnant growth, together with high Inflation. Around 1980 interest rates were between 15 and 20 percent. The US farm economy was still riding high on grain exports, until trade embargoes and boycotts in the 1980's brought that down too. Energy prices stabilized in the 1990's and so did US inflation.
Take a look at your kid's or grandkid's history books once in a while. There was a lot going on back then too, we were just too busy to pay attention.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.