Posted by Steve@Advance on April 02, 2014 at 18:38:25 from (107.203.134.67):
In Reply to: need electrical help posted by AngeloB_1973 on April 02, 2014 at 16:57:14:
The wiring on the old tractors was very basic and simple, so don't be afraid of it.
If you want to keep it 12v, one thing you need to look for is did everything get changed over from 6v to 12v like the coil and lights.
Also it may have been positive ground. The alternator will require a negative ground system and the ignition coil will need to have the + terminal wired to the ign switch, and the - terminal to the distributor lead.
The alternator wiring will depend on which alternator was installed. Most common is a Delco 10SI. Here's a diagram:
http://autorewire.com/tech/article/Delco10SInandd. html
A trip to a good auto supply with wiring supplies will be helpful. The split plastic harness wraps make for a neater job. Soldering and shrink tubing provide a more trouble free result.
Might take a look at the alternator mount, see how well everything lined up, the pulley is right for the belt size, everything is tight, etc.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.