Posted by welled deers on March 27, 2014 at 19:33:11 from (69.168.250.166):
In Reply to: Heat pumps posted by George Marsh on March 27, 2014 at 15:48:47:
Here we go again! You need to be clear that you are talking about air source. Air source is only recommended to be used down to temps of about 20 degrees before switching to a backup. After that their efficiency falls off. The installer should know that. I am aware of several installations here in central Minnesota that are used in that way with excellent results. They are used to provide very efficient air conditioning and heat on warmer days while a backup system is used for colder days. Is that cost effective? Don’t know, but the owners like the arrangement. To condemn all geothermal when you are only presenting Air Source facts is unfair. As I have stated in earlier posts I heat a 5000 square foot house with ground source heat Pump. This past February was my most expensive month ever and my heat pump cost $110.10 in energy. It normally runs $50/60 a month. I do have a backup system, but it has been turned off for the past 10 years. Have never needed it. I did have three independent heat loss calculations done on my home and based on those numbers the pay back for the additional Geo costs were less than 5 years compared to propane, oil or electric baseboard. My pump has been in operation for 13 years with no problems. A neighbor has had his for 28 years with no problems. The person that installed my system installs about 25 units a year and I just talked to him. He has never had to replace a unit. The main moving part is the compressor which is easy to replace if needed. No worse than a commercial refrigerator. Geothermal correctly installed and used is very cost effective and I wouldn’t have anything else.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.