Talk to guys in the local area about the dealers. Where I'm at MF isn't worth a darn cause it's a 90 plus mile drive to a decent dealer. And don't get me wrong, MF made some fine tractors, but my local AGCO dealer isn't worth snot. AC also supported by AGCO. So check out what the locals have to say about dealer support in your area.
The so called power shift (really just a power shift hi low) with neutral as a live PTO point IMO is a PITA. Try doing something that requires, stopping while leaving the PTO running, while try to work the hydraulics, steer and shift R to F or F to R. Sorry a real IPTO is worth a little more money.
To start with while a rotor tiller makes a fine seed bed it also creates hard pan as you are tilling. So not in your best interest.
I would look for a post 1960 tractor. I'd say if you intend to have a loader PS is a must. Utility type tractors like the Ford 2000/3000 will do most of what you are asking except the tiller (too fast most models) and the bale spear, too small. The MF tractors other mentioned will work too. There are some good JD, IH and Case ones out there too that fit the bill.
As far as pushing snow goes, how much? If you have never plowed snow you will learn that any repeated snowfalls will require planning on where to stack you piles to make sure you have room for follow accumulations. Plus any gravel/sand/dirt areas you are going to move some material where you don't really want it. Here is where I'll offer a suggestion. 2 tractors. One smaller on for the lighter work and a larger one that can not only move bales but can also run a snow blower. You don't have to worry about stacking snow with a blower. If set up right moves little if any loose materials.
It would help if we were to know what basic area you are in and what your top dollar amount is to spend. You may have a compact utility desire and an AC C budget.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Smells - by Curtis Von Fange. We are continuing our series on learning to talk the language of our tractor. Since we can’t actually talk to our tractors, though some of the older sect of farmers might disagree, we use our five physical senses to observe and construe what our iron age friends are trying to tell us. We have already talked about some of the colors the unit might leave as clues to its well-being. Now we are going to use our noses to diagnose particular smells. ELECTRICAL SMELLS
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
