As a hydronic design engineer, for residential systems I ALWAYS zone with pumps.
In the past circulators use to cost more than zone valves, but that is simply not the case anymore. Manufactures like Grundfos, Taco, Bell & Gossett, etc all make cartridge circulators that should fit your application (pump sizing still needs to be performed however). You can buy a zone circulator for around $80 and a zone valve of any decent quality is going to run you in the neighborhood of $70. Not to mention having multiple zones, if one pump does happen to go down, you still aren't dead in the water.
The second item is simplicity (pump zoning) - Thermostat calls, pump turns on, boiler starts. (Valve zoning) - Thermostat calls, valve actuates, end switch makes, pump starts, boiler starts.
The third pro in pump zoning is the simplicity of controls. You do not have to run extra wiring for zone valve end switches.
This is overly simplified, but I can honestly say I haven't designed or quoted a RESIDENTIAL job in years using zone valves...and there is a reason for that.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
