Posted by robert major on February 10, 2014 at 13:01:13 from (216.81.21.150):
In Reply to: Strenious farm chores posted by Harvey2 on February 10, 2014 at 08:26:14:
Still got some now. Got 6 Biotech hog barns. Put round 5x6 bale of straw in, cut the strings, if you're lucky it's only the top 6" thats frozen solid, try to peel that off, then unroll the bale down the barn turn it at the bottom push back up the other side. If you're unlucky you get 6 bales a day that are frozen solid and have a flat spot on so you struggle to push them and 180 hogs in the barn don't help either. Add the fact that you've probably got to dig snow to get the tractor out for 20 mins, chisel frozen crap to get the pig barn doors open, and deal with the end tarps, and the last 3 or 4 weeks its been Minus 20 oc and nearer 30-40 0c with wind chill. It's being a brutal job this winter. Regards Robert
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.